AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Linksys router settings4/7/2023 ![]() ![]() Your Linksys Smart WiFi router is now set to Bridge Mode using the Classic Firmware settings.Note: Make sure you keep the SSID for both routers different from each other to avoid any future conflict. Now, connect the main router to the internet port of the Linksys router.Subnet Mask: The values you select for this field must be similar to those of the main router.ĭefault Gateway: This value will define the IP address of the main router. Internet IPv4 Address: This is the address used for the Linksys router, and the value for this must be in the same range as the main router. You can now enter the appropriate IP address, Subnet Mask, and Default Gateway for the router device in the respective fields and then click on the Save Settings button.From the Network Setup tab, under the router address window, make the selection as ‘ Specify an IP address’.From under the ‘ Internet Setup’ tab select the ‘ Internet Connection Type’ as ‘ Bridge Mode.’ You will now be redirected to the router’s web-based setup page.Check the button next to “Do not show me this again.” and click on the Ok button.Ĭonfiguring Bridge Mode on Linksys router You might see a small warning window pop up on the screen.You can use “ admin” as both username and password. The default username and password details can be found on the product label.Type in the login details in the respective fields and click OK. You will now see a prompt for the router’s username and password on the computer screen.Launch a compatible web browser and in the address bar, type the default web address or the IP address 192.168.1.1 and press Enter.Now, plug one end of the power adapter into an electrical outlet and the other end into the Linksys router device.Establishing a wireless connection between any two routers will not help. Note: Make sure the router that’s set to Bridge Mode remains connected to the main router using an ethernet cable. Do not connect the cable to the internet port for now.Connect an ethernet cable from your computer to any of the LAN ports on the router that supports the Bridge Mode capability.To proceed with the setup process, here are some instructions you can follow: Linksys Smart WiFi router supporting Bridge Mode.The main router can be your modem/router provided by the ISP. ![]() Prerequisitesīefore you configure your Linksys router to bridge mode, make sure you have the following: If you have set up your router using the same, you will need to reset the same to factory defaults before you configure it in bridge mode. Secondly, the features associated with the Linksys Connect software will get disabled automatically once the Bridge Mode is set up. This process is essentially called cascading. The router will no longer act as a DHCP server and the built-in firewall along with the NAT features will also get disabled.īut, if you are looking for a secured network setup that provides improved network performance without losing the old router’s capabilities, you can arrange your new router next to the main router. ![]() When you set up your Linksys router in bridge mode, it will lose its router capabilities and transform into an access point. This blog will walk you through the steps to access a Linksys router in bridge mode and improve the functionality. Furthermore, if you wish to connect the router to a modem/router provided to you by your ISP, or disable the router functionalities so it can work with third-party devices, you can set up your router to work as a bridge. Moreover, if you are looking to connect two routers to share the network resources or use a router as an additional access point, using the Linksys bridge mode can help. However, setting them up to work in bridge mode can help you accomplish varied device functionalities. Linksys routers are self-sufficient and can be used as standalone devices for network propagation. ![]()
0 Comments
Read More
Leave a Reply. |